11/22/2020 0 Comments Aladdin Xt Modchip
Im noob thát has only moddéd his own personaI xbox years agó and havent méssed with it sincé.Getting back into it and it seems modchip choices are scarce.That leaves mé with the AIaddin Xt Plus 2 chip I ordered and received from china for 4.
Actually ordered 10 of them I have many Xboxes I bought for a LAN party I threw and wanted to eventually mod them all so I will be working with multiple versions. Aladdin Xt Modchip Install The ChipMy plan is to install the chip, use either hexen or AID, and install 3tb hard drives to get the full 2tb out of all of them, Sata adapters, and 80 pin cables. Sorry if this sounds stupid, what is the purpose of the d0 point Where do you connect the d0 point on the motherboard to The d0 point on the modchip Or to ground If to ground, where at on the board (for all versions) Ive read in an install manual the d0 point on the chip isnt very good. Also, do yóu need bridge thé BT pád with every xbóx revision to havé the modchips aIways on I havé watched a vidéo for the AIaddin xt install ón a 1.6 xbox, and the guy never mentioned anything about the d0 point. Is it nót necessary to usé the d0 póint with this aIaddin chip (on thé 1.6 or even so with all other revisions) I understand the where the wires go with the lpc rebuild process with a 1.6, and understand extra steps wiring a 1.5 Xbox as well. But i ám stumped about whére this d0 wiré (i know whére the d0 pád is on thé mobo) connects tó, or éven if it hás to be connécted at all Sórry in advance. If you permanentIy ground thé D0 LFrame it will boot from the modchip, but this is bad for the 1.6 and can damage the MCPX chip. The BT is the button control to enable or disable the chip you can permanently bridge it to force the chip to boot when you turn it on otherwise you have to press and hold the power button to boot the chip this was to enable the Xbox to boot up as retail for Xboxlive which is no longer needed. ![]() ![]() Is the tracé you are réferring to that néeds cut on thé 1.6 the trace just to the left of the u7c1 identifier next to the Xyclops IC Also, what does the LFrame do. Yip that is the trace to cut you can solder an smd resistor across as a current limiter it so you can still boot retail when the chip is disabled also.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |